PDA

View Full Version : Inner holes size



farfons
09-21-2017, 08:20 AM
Hi, i'm new in the forum, i'm experiencing an annoying problem. The inner holes of any figure i print are smaller than than the measures of the draw, for a square with side of 150mm with an inner square with side 100mm the printed result is an outer square of ~150,07mm but an inner square of ~98,4mm. What i'm doing wrong? Have you experienced similar issues? With external measures enough close to draw i was thinking about a slicer setting problem (cura 2.7). Thanks

bolsoncerrado
09-21-2017, 04:01 PM
See if you're underextruding or overextruding, or if your extruder is calibrated or not. Here you have some hints:


https://www.youtube.com/watch?v=YUPfBJz3I6Y