PDA

View Full Version : Favorite Filaments?



Ap0c4lyptyc
01-24-2018, 01:01 AM
Hello All!

I was wondering what all filaments people here like to use with the Cube 3? There is a post here in the forum but it seems derelict? I just recently bought some PLA filament from AMOLEN off of Amazon and it was junk! Brittle prints, bad stringing and it got too thick to fit through the drive gears. I couldn't even force it through. I just returned it this morning and ordered some PLA from MatterHackers to give that a shot. What do you all think?

TommyDee
01-24-2018, 01:25 AM
http://www.print3dforum.com/showthread.php/914-Filament-Review

It's not that it is derelict, it is more the case that people don't seem to think much of the filaments they buy so they also have no inclination to post those results. Or they already have a favorite and is either included, or they have a favorite and do not wish to share.
Maybe the post should be stickied.