View Full Version : dumb question, how to distinguish which side of the film is facing upward?

10-19-2016, 12:41 PM
I am having a hard time using FTD to print,
it just dont stick to the plate, with lots of failure.
I am trying to replace the film but I forgot which side should be facing upward.
And is there any tips on getting the print to stick to the plate ?


10-19-2016, 02:59 PM
Take a postit and try to glue it on the film, if it sticks well, then you're good to go. if it wont stick, wrong face, try again.

08-31-2022, 06:39 PM
By bolsoncerrado in forum Morpheus 3D Printers

09-12-2022, 03:23 AM
thanks for sharing