TommyDee
Super Moderator
Find latest postsMini Statistics
- Join Date
- 11-22-2016
- Last Activity
- 01-30-2023 11:44 PM
Recent Visitors
- aidanthehorrible,
- Cubical,
- dangel67,
- gHoststalker,
- JohnTee,
- Mailbot,
- MikeFVF331,
- nbvnbv,
- njpdlstarcom,
- Radek6623
- Tab Content
- TommyDee's Activity
- About Me
- Friends
- Post Thanks / Like
-
Older Activity
-
01-30-2023, 11:44 PMAll I know about PETG is that in Cube3 using the Ekocycle slicer does well with PETG. I turn the temps down to 250C. I have no idea where to start...22 replies | 26891 view(s) -
01-30-2023, 03:19 AMNice find. Yes, ReCube can regenerate your cartridge. http://www.print3dforum.com/showthread.php/1712-Building-Tomuro-s-Circuit1 replies | 36 view(s)
-
01-30-2023, 03:16 AMClogged nozzle more than likely. They use a visual sensor to see filament flow through the driver above the nozzle.7 replies | 2147 view(s)
-
01-30-2023, 03:14 AMThat is a good idea to back up the flash drive @Cubical. There are two .bin files that are coded to your printer's mac address. It is FAT32 IIRC. ...5 replies | 677 view(s)
-
01-09-2023, 07:53 PMWithdrawing the filament can be a problem with the bulb coming out of the nozzle being bigger than the tube being drawn through. I normally clip the...157 replies | 623514 view(s)
-
01-09-2023, 06:00 PMSomeone did one of those but I am not a fan. It is a fairly straight forward operation. Not sensing when you reached the tip with fresh filament is...157 replies | 623514 view(s)
About TommyDee
Basic Information
Statistics
Total Posts
- Total Posts
- 3,466
- Posts Per Day
- 1.53
General Information
- Last Activity
- 01-30-2023 11:44 PM
- Join Date
- 11-22-2016
- Referrals
- 15
7 Friends
Showing Friends 1 to 7 of 7
01-30-2023
- 03:21 AM - TommyDee clicked Likes for this post: Hotend & Nozzle Need Help by CubicalRicciEU, it's been a...
01-09-2023
- 03:04 AM - TommyDee clicked Thanks for this post: Salvage - PC4M5 fitting +Bonus by JohnTeeI know, old thread! But...