MegaloDon
Expert 3D Printer
Find latest postsMini Statistics
- Join Date
- 01-25-2017
- Last Activity
- 06-10-2018 07:43 AM
More 3 Friends
Recent Visitors
- 3DSurfer,
- Ashena,
- bobskinner,
- JackMeoff,
- joecochran1980,
- KHMusicMan,
- slx612,
- techbeni,
- tprothma,
- ztoddman1
- Tab Content
- MegaloDon's Activity
- About Me
- Friends
- Post Thanks / Like
-
Older Activity
-
10-16-2018, 08:38 AMFirst off you need to clean everything of molten plastic. Heat up to mild temp 150 or so and use a metal brush to clean up the mess as much as...1 replies | 45 view(s)
-
10-09-2018, 05:20 PMDid you try contacting them directly first? Can you take a picture of the LCD to see the exact message? Also can you take a picture of the extruder...4 replies | 109 view(s)
-
10-09-2018, 04:00 PMBroken thermistor wire maybe? Where did you buy it?4 replies | 109 view(s)
-
10-04-2018, 08:18 AMYes, it does seem your thermistor cables are bad/cut. YOu should ask for a replacement if under warranty.4 replies | 162 view(s)
-
10-02-2018, 08:02 PMBut whats the exact message on the display? Thermal Runaway? May be the wire is internally "cut" and it breaks the connection on certain...4 replies | 162 view(s)
-
09-26-2018, 08:19 AMIt could also be something inside the power supply... I'dn't leave it quite unattended...5 replies | 186 view(s)
-
09-26-2018, 08:18 AMMight be a motor driver overloaded or going wrong hmmm.... not that easy to solve. Where did you get your printer?5 replies | 186 view(s)
-
09-24-2018, 08:31 AMbolsoncerrado replied to a thread Bed heating power cable hooked by the bed belt tensioner in Rapide Lite 3D PrintersYou may want to put the belt tensioner upside down and retry?2 replies | 126 view(s)
About MegaloDon
Basic Information
Statistics
Total Posts
- Total Posts
- 479
- Posts Per Day
- 0.76
General Information
- Last Activity
- 06-10-2018 07:43 AM
- Join Date
- 01-25-2017
- Referrals
- 2
3 Friends
Showing Friends 1 to 3 of 3
No results to show...