Tab Content
  • APCollyer's Avatar
    06-22-2017, 07:06 PM
    Link is at the first page of this thread I think 1) Download this Tool into a file and unzip it 2) Load the Tool by double clicking, open 3)...
    160 replies | 20172 view(s)
  • APCollyer's Avatar
    06-22-2017, 05:05 PM
    SUCCESS on the CubePro start 20% end 20% so works on the Trio. Just need to work on best feeding mechanism into the CubePro Cabinet
    160 replies | 20172 view(s)
  • APCollyer's Avatar
    06-22-2017, 05:02 PM
    Jason I have just done the Hack on the CubePro Trio firmware as advised and apparently you need only to hack your machines current Firmware using...
    160 replies | 20172 view(s)
  • APCollyer's Avatar
    06-22-2017, 10:41 AM
    Thanks all, have just done the firmware patch for v 2.00 and will try a print to see that it works. Appreciate all of your hard work in...
    160 replies | 20172 view(s)
  • APCollyer's Avatar
    06-21-2017, 08:16 PM
    Thanks TommyDee Been in touch with Greg regards the Rekindle but though give the Hack a try I have a CubePro Trio with V2.00/v2 but thought...
    160 replies | 20172 view(s)
  • APCollyer's Avatar
    06-19-2017, 12:25 PM
    APCollyer replied to a thread [ THING ] Cube 3 filament winder in Cube3
    Hi Tommy As you can see internal spool different but guess winder works the same in principal. I was concerned re the spool winder clamp...
    11 replies | 805 view(s)
  • APCollyer's Avatar
    06-17-2017, 06:41 PM
    APCollyer replied to a thread Filament Review in Cube3
    Based in the UK so of course need local suppliers or pay lots of shipping and possibly import duty :( but thanks for the headsup will look at the...
    98 replies | 5320 view(s)
  • APCollyer's Avatar
    06-17-2017, 05:27 PM
    APCollyer replied to a thread [ THING ] Cube 3 filament winder in Cube3
    Good job Would this work on the CubePro Cartridges and has someone modded this for that purpose? Andrew
    11 replies | 805 view(s)
  • APCollyer's Avatar
    06-17-2017, 03:31 PM
    APCollyer replied to a thread Filament Review in Cube3
    So I read through all the pages and "Inland" looks favorite from the comments so far . Is this the case for ABS version? About to try the...
    98 replies | 5320 view(s)
  • APCollyer's Avatar
    06-15-2017, 10:49 PM
    Ok Guys new to 3D printing but got a '3DS Cubepro Trio' before realised would cost me an arm and leg in cartridges. Have several with 50% or less...
    160 replies | 20172 view(s)
No More Results
About APCollyer

Basic Information

Statistics


Total Posts
Total Posts
10
Posts Per Day
0.86
General Information
Last Activity
06-22-2017 07:06 PM
Join Date
06-15-2017
Referrals
0
No results to show...