Tab Content
  • Ardoneye's Avatar
    07-17-2018, 07:07 PM
    Ardoneye replied to a thread Universal Hub in Cube3
    The amount of plastic and parts put me off attempting the solution. I'm in a rush to build a lack enclosure and replacement desk at the moment and...
    28 replies | 703 view(s)
  • Ardoneye's Avatar
    07-17-2018, 06:09 PM
    Ardoneye replied to a thread Universal Hub in Cube3
    Printed a good 10 hours or so with the original filament with this setup without anything keeping the tubes in on either end of the nuts and no...
    28 replies | 703 view(s)
  • Ardoneye's Avatar
    07-15-2018, 06:46 PM
    Ardoneye replied to a thread Universal Hub in Cube3
    These were printed with a completely standard stock ABS cartridge without modification. I was fully tightening the end without paying attention and...
    28 replies | 703 view(s)
  • Ardoneye's Avatar
    07-15-2018, 05:08 PM
    Ardoneye replied to a thread Universal Hub in Cube3
    I’ll see how desperate I get before I potentially end up begging for you to send it to family west side :) Thank you! Bit of an interesting one, I...
    28 replies | 703 view(s)
  • Ardoneye's Avatar
    07-15-2018, 12:18 PM
    Ardoneye replied to a thread Universal Hub in Cube3
    I think I might give it a go in the coming weeks once some other projects are out the way. I’m not feeling quite so adventurous with the m6x1 hard...
    28 replies | 703 view(s)
  • Ardoneye's Avatar
    07-14-2018, 07:06 PM
    Ardoneye replied to a thread Universal Hub in Cube3
    Cheers Tommy, very helpful. Pretty much sums up what I ended up doing last night in the end after a few drinks the whole design just made sense....
    28 replies | 703 view(s)
  • Ardoneye's Avatar
    07-13-2018, 11:26 PM
    Ardoneye replied to a thread Universal Hub in Cube3
    All credits to you good sir, the colour on the other hand would be stock 3ds neon green, I've got 8 original carts still to be used :) That...
    28 replies | 703 view(s)
  • Ardoneye's Avatar
    07-13-2018, 09:43 PM
    Ardoneye replied to a thread Universal Hub in Cube3
    Great work TommyDee, I just printed this in ABS from a stock cartridge with the files meant for PLA. (Cube3_b2b_tubenut, Cube3_B2B_M6_nozzle,...
    28 replies | 703 view(s)
No More Results
About Ardoneye

Basic Information

Statistics


Total Posts
Total Posts
15
Posts Per Day
0.04
General Information
Last Activity
Yesterday 07:14 PM
Join Date
06-18-2017
Referrals
0
No results to show...