Tab Content
  • JohnTee's Avatar
    03-15-2019, 05:38 AM
    JohnTee replied to a thread [ HOW TO ] Building Tomuro's Circuit. in Cube3
    The ad looks very good - clear and complete description IMO. Very good deal! Oh, and my nano does have those pads - I just didn't know where to...
    25 replies | 906 view(s)
  • JohnTee's Avatar
    03-13-2019, 10:03 PM
    JohnTee replied to a thread [ HOW TO ] Building Tomuro's Circuit. in Cube3
    How many do you have, Tom?? :p "Basically, configure a NANO as an ISP and load the current Arduino bootloader onto a properly connected NANO." ...
    25 replies | 906 view(s)
  • JohnTee's Avatar
    03-13-2019, 08:27 PM
    JohnTee replied to a thread CubePrint on Linux ??? in Cube3
    No idea - maybe using some of it's UI functions?
    4 replies | 37 view(s)
  • JohnTee's Avatar
    03-13-2019, 08:06 PM
    JohnTee replied to a thread [ HOW TO ] Building Tomuro's Circuit. in Cube3
    <Thumbs Up> on not getting entangled - hadn't thought about that aspect. Point taken on the fact someone can buy a $3 nano and make it work...BUT......
    25 replies | 906 view(s)
  • JohnTee's Avatar
    03-13-2019, 07:39 PM
    JohnTee replied to a thread CubePrint on Linux ??? in Cube3
    Yep - thanks for the reminder. Didn't hit that roadblock yet, but I have now installed OpenGL in the form of "freeglut" & dependencies. The first...
    4 replies | 37 view(s)
  • JohnTee's Avatar
    03-13-2019, 05:51 AM
    JohnTee started a thread CubePrint on Linux ??? in Cube3
    A quick attempt at installing CubePrint 3.04 under WINE on Linux Mint 19.1 Tessa failed, with a message about needing Internet Explorer 10 or later....
    4 replies | 37 view(s)
  • JohnTee's Avatar
    03-13-2019, 04:21 AM
    JohnTee replied to a thread [ HOW TO ] Building Tomuro's Circuit. in Cube3
    Personally, I think you are at least 50% low on your pricing! Would it be reasonable to bump it up enough to make it worth your while, plus maybe...
    25 replies | 906 view(s)
  • JohnTee's Avatar
    03-13-2019, 04:16 AM
    I presume you would put back a stop-extrude for each move to/from the cooling tower? Else you would have a "bit" of stringing!?! From here, that...
    2 replies | 82 view(s)
  • JohnTee's Avatar
    03-11-2019, 08:26 PM
    JohnTee replied to a thread [ HOW TO ] Building Tomuro's Circuit. in Cube3
    Those look super spiffy. Can the nano connect to a PC so you can use the ReCube Pro chip programming commands (i.e., change material, color,...
    25 replies | 906 view(s)
No More Results
About JohnTee

Basic Information

Statistics


Total Posts
Total Posts
149
Posts Per Day
0.38
General Information
Last Activity
03-15-2019 05:38 AM
Join Date
02-23-2018
Referrals
0
No results to show...