Tab Content
  • JohnTee's Avatar
    07-15-2018, 11:48 PM
    JohnTee replied to a thread Filament Review in Cube3
    LOL - that's what happens when you live too long!! :rolleyes: Try again: MakeShaper. https://www.makeshaper.com/
    136 replies | 21118 view(s)
  • JohnTee's Avatar
    07-15-2018, 09:43 PM
    JohnTee replied to a thread Filament Review in Cube3
    Nice piece of work! FWIW, I've had some fairly good results with my one spool of MakerShaker ABS. I print the first layer at 245 and subsequent at...
    136 replies | 21118 view(s)
  • JohnTee's Avatar
    07-06-2018, 04:43 AM
    JohnTee replied to a thread The Printing Lounge in Cube3
    That cleaned up amazingly well... nice discovery!
    166 replies | 19761 view(s)
  • JohnTee's Avatar
    06-28-2018, 02:14 AM
    JohnTee replied to a thread Daily Print Sagas in Cube3
    It sure sounds like they sent something other than ABS. Likely PLA mis-labeled. Is there a Home Plastic Chemical Analysis Kit on the market yet??...
    131 replies | 18645 view(s)
  • JohnTee's Avatar
    06-28-2018, 02:07 AM
    @TD - FWIW I've been printing with my ABS B2B nozzel for a few weeks. Works great! All parts are ABS. I also made one from 3DS Ekocycle PET. The ABS...
    33 replies | 2192 view(s)
  • JohnTee's Avatar
    06-25-2018, 07:27 PM
    Right!! (Thanks for the reminder...) The cartridge has to have less than 100% remaining in order for the hack to work. Meaning, if you have any...
    374 replies | 80528 view(s)
  • JohnTee's Avatar
    06-25-2018, 06:13 PM
    @astruns - If you are asking whether you need to do something in order to use a different cartridge/filament, then: No. Once you install the...
    374 replies | 80528 view(s)
No More Results
About JohnTee

Basic Information

Statistics


Total Posts
Total Posts
76
Posts Per Day
0.51
General Information
Last Activity
07-16-2018 12:10 AM
Join Date
02-23-2018
Referrals
0

06-28-2018