Tab Content
  • JohnTee's Avatar
    02-01-2023, 06:00 AM
    JohnTee started a thread Looking for best source for Cube3 power supply in Cube3
    I've gotten a couple of 24v 5A supplies in the past from https://www.mpja.com/. They came with the proper 4 pin connector. NOW they have a similar...
    see more
    0 replies | 25 view(s)
  • JohnTee's Avatar
    01-09-2023, 06:10 PM
    JohnTee replied to a thread BFB (G-Code) for Cube 3 in Cube3
    Thanks! I agree about manually pushing the new filament back in. I was thinking about automating only the retraction part. Being lazy and forgetful,...
    see more
    158 replies | 623588 view(s)
  • JohnTee's Avatar
    01-09-2023, 05:44 AM
    JohnTee replied to a thread BFB (G-Code) for Cube 3 in Cube3
    @TommyDee - Side note, hope this isn't too much of an intrusion... Have you written a Cube print file to heat up and retract filament from the...
    see more
    158 replies | 623588 view(s)
  • JohnTee's Avatar
    01-07-2023, 07:52 PM
    JohnTee replied to a thread Salvage - PC4M5 fitting +Bonus in Cube3
    I know, old thread! But I was trolling to try to find a recommendation for a source of 4x2 tubing and ran across this. Man, TD - you sure do...
    see more
    34 replies | 20666 view(s)
No More Results
About JohnTee

Basic Information

Statistics


Total Posts
Total Posts
205
Posts Per Day
0.11
General Information
Last Activity
Yesterday 07:17 PM
Join Date
02-23-2018
Referrals
0

01-09-2023