Tab Content
  • sam's Avatar
    01-04-2019, 02:46 PM
    sam replied to a thread gap in printed part in CR-10
    I up dated cura-2 too cura-3.6 and I think it runs the top and bottom layers in a different pattern. I think that will work better. Sam.
    5 replies | 154 view(s)
  • sam's Avatar
    01-03-2019, 06:52 PM
    sam replied to a thread gap in printed part in CR-10
    If you look closely you will see that the gap in the middle of the parts. I think that it has to be in the slicer setting, because I can see them on...
    5 replies | 154 view(s)
  • sam's Avatar
    01-03-2019, 12:02 PM
    sam started a thread gap in printed part in CR-10
    Hi I got my cr10 mini for Christmas, and use cura for slicer. On all most every printed part I get a gap on the top and bottom of them. It looks...
    5 replies | 154 view(s)
No More Results
About sam

Basic Information

Statistics


Total Posts
Total Posts
11
Posts Per Day
0.04
General Information
Last Activity
01-05-2019 12:23 PM
Join Date
03-23-2018
Referrals
0
No results to show...