razor81
Regular 3D Printer
Find latest postsMini Statistics
- Join Date
- 02-16-2020
- Last Activity
- 02-04-2023 12:32 PM
More 2 Friends
Recent Visitors
This page has had 17,359 visits
- Tab Content
- razor81's Activity
- About Me
- Friends
- Post Thanks / Like
-
Older Activity
-
Today, 02:56 AMFollow the instructions from the first page step by step. The batch file uploads F/W to the Arduino. Batch files are "run".34 replies | 50777 view(s) -
Today, 02:42 AMOne could try the last 4 digits of the printer's serial number.13 replies | 7842 view(s)
-
Yesterday, 04:33 PMhttp://www.print3dforum.com/showthread.php/1892-The-ReCube-Wand-Help-Thread This is a separate help thread for ReCube.155 replies | 671045 view(s)
-
Yesterday, 04:31 PMGive this thread a shot: http://www.print3dforum.com/showthread.php/1892-The-ReCube-Wand-Help-Thread488 replies | 1047385 view(s)
-
02-04-2023, 12:08 AMNot for Cubify products @camilasaunder89. It installs itself perfectly.12 replies | 1355 view(s)
-
02-04-2023, 12:01 AMFrom the latest information gathered here, the tool to hack the CubePro is no longer being offered by the originator. We tend to respect the wishes...488 replies | 1047385 view(s)
-
02-01-2023, 12:45 AMNice work @Kiza! Always good to see you back and with cookies no less ;]188 replies | 283609 view(s)
-
01-30-2023, 11:44 PMAll I know about PETG is that in Cube3 using the Ekocycle slicer does well with PETG. I turn the temps down to 250C. I have no idea where to start...22 replies | 27128 view(s)
-
01-30-2023, 03:19 AMNice find. Yes, ReCube can regenerate your cartridge. http://www.print3dforum.com/showthread.php/1712-Building-Tomuro-s-Circuit1 replies | 114 view(s)
-
01-30-2023, 03:16 AMClogged nozzle more than likely. They use a visual sensor to see filament flow through the driver above the nozzle.7 replies | 2228 view(s)
-
01-30-2023, 03:14 AMThat is a good idea to back up the flash drive @Cubical. There are two .bin files that are coded to your printer's mac address. It is FAT32 IIRC. ...5 replies | 733 view(s)
-
01-09-2023, 07:53 PMWithdrawing the filament can be a problem with the bulb coming out of the nozzle being bigger than the tube being drawn through. I normally clip the...158 replies | 623964 view(s)
-
01-09-2023, 06:00 PMSomeone did one of those but I am not a fan. It is a fairly straight forward operation. Not sensing when you reached the tip with fresh filament is...158 replies | 623964 view(s)
About razor81
Basic Information
About razor81
- Location:
- Germany
- Interests:
- obviously 3d printing.. airbrush...
Statistics
Total Posts
- Total Posts
- 145
- Posts Per Day
- 0.13
General Information
- Last Activity
- 02-04-2023 12:32 PM
- Join Date
- 02-16-2020
- Referrals
- 0
No results to show...