Search:

Type: Posts; User: dwhttnbrg

Search: Search took 0.00 seconds.

  1. Replies
    47
    Views
    2,083

    [ THING ] The hole is slightly bigger than the tubing, its...

    The hole is slightly bigger than the tubing, its a snug fit.
  2. Replies
    47
    Views
    2,083

    [ THING ] No, I used the drill block that was on here.

    No, I used the drill block that was on here.
  3. Replies
    47
    Views
    2,083

    [ THING ] Yes Sir, just open it up and slide it back and...

    Yes Sir, just open it up and slide it back and cut it where it meets the ridged part. the remove the hot end and drill. Once the hole is there, reinstall the hot end as normal and pull the pipe...
  4. Replies
    47
    Views
    2,083

    [ THING ] 2181This is what I used. The tubing connected to...

    2181This is what I used. The tubing connected to the nozzle was cut at the end where it connected to the cartridge. I then pulled it up through the drilled hole and connected it with the festo...
  5. Replies
    47
    Views
    2,083

    [ THING ] I did this, but pulled the tubing from inside the...

    I did this, but pulled the tubing from inside the hot end out through the hole. I then used a Festo 3mm to 3mm push connector and connected the 2 pieces of tubing. WORKS GREAT!
  6. [ THING ] Corrected the holder, seems to be a little better...

    Corrected the holder, seems to be a little better now. I have printed for 6 hours without any issues.
  7. Replies
    2
    Views
    145

    Nothing wrong, Just curious. Want to see how...

    Nothing wrong, Just curious. Want to see how others are running them, software, tweaks etc
  8. Replies
    2
    Views
    145

    Anyone own a Solidoodle 3?

    Just curious if anyone else has one of these.
  9. [ THING ] I have 3mm OD tubing. I just swapped from a piece...

    I have 3mm OD tubing. I just swapped from a piece of PTFE to some thicker walled stuff. Here is what I currently have going. 21752176

    - - - - - - - - - -

    no, you can watch it pushing it the...
  10. [ THING ] I am also having issues with the filament pushing...

    I am also having issues with the filament pushing the PTFE tubing out of the fitting after 30 min or so of printing.
  11. [ THING ] I am using little screws. What size are the...

    I am using little screws. What size are the screws for the big holes?
  12. [ THING ] Have mine printed and working, but it seems to be...

    Have mine printed and working, but it seems to be pushing really hard against the fitting. Anyone else notice this. Worried about it breaking with just the 2 screws in the front.
  13. Replies
    1
    Views
    86

    It's Alive!!!!

    2127Finished the mod to a degree. I need a better spring, this is one I had, but it's to big for the loop. It stays in place like it is until I can get the right one.
  14. Replies
    4
    Views
    128

    Working on the replacement now. Flameless torch??...

    Working on the replacement now. Flameless torch?? Light the electric lighters??
  15. Replies
    4
    Views
    128

    Bulk Filament Spider Webs

    I have noticed that I am having "spider web" issues with my bulk PLA. Is there a way to back the temp off just a bit? Its not a terrible thing, and a bit of sanding usually gets rid of them. Just...
Results 1 to 15 of 15