Search:

Type: Posts; User: dougk12

Search: Search took 0.00 seconds.

  1. Replies
    26
    Views
    7,310

    No, not at all. I've always wrestled with getting...

    No, not at all. I've always wrestled with getting the filament to catch when reloading. Not sure if this is a common issue or not but it was very frustrating for me. This solves that and the only...
  2. Replies
    26
    Views
    7,310

    That guide is held in place with nuts & bolts. It...

    That guide is held in place with nuts & bolts. It appears you are missing a couple at the top of it.

    I would recommend losing that altogether. It's purely aesthetic and serves no functional...
  3. Replies
    26
    Views
    7,310

    The small triangle that goes in the bottom right...

    The small triangle that goes in the bottom right hand corner of that assembly uses a longer bolt and mounts threw the bottom right hand hole. It isn't required - I believe it's purpose is to prevent...
  4. Replies
    26
    Views
    7,310

    Sorry but the print bed is gone. Cleaning up the...

    Sorry but the print bed is gone. Cleaning up the old bed and putting lokbuild over it is a great option. Its a great solution.

    The only 2 tools needed for the print head assembly are the 2.5mm...
  5. Replies
    26
    Views
    7,310

    Yep, the one piece aluminum body is broken. I've...

    Yep, the one piece aluminum body is broken. I've seen that occur if the bed isn't seated fully or someone fires off a new print while the last print job is still on the plate.

    If I had a spare...
Results 1 to 5 of 5