Search:

Type: Posts; User: TommyDee

Search: Search took 0.02 seconds.

  1. Replies
    14
    Views
    16,355

    I was afraid of that. It just digs a deeper hole...

    I was afraid of that. It just digs a deeper hole to not have the PLA chip.

    I am suggesting to use the native setup for CubePro, yes.
    In order to that with an ABS chip, you will need CubePro...
  2. Replies
    14
    Views
    16,355

    Aha, yes, you need to go back to a known profile....

    Aha, yes, you need to go back to a known profile. I highly recommend tuning with CubePro. That way you know it is right for the printer. Use the PLA setting for PLA prints obviously.

    - - - - -...
  3. Replies
    14
    Views
    16,355

    The frothiness of the ABS may be pointing to a...

    The frothiness of the ABS may be pointing to a need to do a cold pull. I suspect you have some carbon buildup at the small aperture.

    A cold pull is a method where you melt a specific material...
  4. Replies
    14
    Views
    16,355

    Being PLA, it should be more consistent. It...

    Being PLA, it should be more consistent. It looks like it is "frothing". How does it print?
  5. Replies
    14
    Views
    16,355

    Sorry, no. If this were me, which it will be one...

    Sorry, no. If this were me, which it will be one day, I would source and purchase a new nozzle and get the printer back up and functioning and then see what could be done with the clogged nozzle...
  6. Replies
    14
    Views
    16,355

    I so dread having to do that. I don't have any...

    I so dread having to do that. I don't have any advice over and above what 3DS has posted. I know that isn't much help. My take is normally to get the spare and then mess with the failed unit.
Results 1 to 6 of 6