Search:

I can easily include a lever switch and the hardware needed to make such a feature for you. There are some serious pinch points on the chassis, and could easily do some damage if you reach in there...

I wouldn't worry about the relay board. Yes, it was made by 3DS but I looked at it and it seems to have all the right T's crossed if I remember right... good AC side isolation, different sides of the...

I use cura, but the control board will be running Marlin, so anything that can output gcode for that (anything that works with reprap basically).

The heater is a DBK Cirrus 60 heater. Running on...

I don't understand why. I think the CubePro heated chamber is better and removes the need for a heated bed. Having an overall temperature you can control limits the possibility of air drafts and...

There's no heated bed, it's a heated chamber.

It's an AC heater with a 24v DC fan. I'm not sure the max temp, the would be in the individual material profiles I think.
3091

really weird ... the images were showing up for me before. I went back and added pictures to other posts.

It wasn't a bug really ... the printer was out of it's case so the heater was trying to heat the room ... also it was unplugged :P


the board is a little more complicated than just a thermistor...

Tommy- Good stuff, I'll have to read through all that again when I have my head out of my ass...embly code. :D

Ya I know there's a lot I've missed over the years, I really should read up on all...

Sounds good Tommy,

Now on a bit of a side topic, you remind me of when I first got my CubePro (back in 2014). I didn't like how they sliced their files, and wanted vase mode so I could 3D print...

I'm using TMC2208 stepper drivers with 1/256th steps ... nearly silent running with first tests.



You and I must be using different software :)
I could never get the fine tuning I wanted with...

So I don't have a Cube 3 but if anyone wanted to send me one (or the guts at least) I'd be willing to take a look.

I googled some images, and the motherboard's look very similar. Can someone take...

I'm working on a replacement controller for the CubePro. While I do plan to sell these, the code will be open source (Marlin) and I'll release the board design files at some point. Currently I'm...