Search:

Type: Posts; User: rlb245

Search: Search took 0.00 seconds.

  1. Replies
    9
    Views
    5,939

    Well sir you're absolutely right on that one...

    Well sir you're absolutely right on that one Tommy! Was looking at the bios! From what I can see no support! Sorry for the late reply but I was in Seattle all winter working and sense I've been...
  2. Replies
    9
    Views
    5,939

    Thanks Tommy for the reply! I probably should...

    Thanks Tommy for the reply! I probably should have told you up front that it's a EKO! but I recalibrated the unit and sent the table cap with a piece of paper and everything is working really nice...
  3. Replies
    9
    Views
    5,939

    The Cubify Print program has a settings tab that...

    The Cubify Print program has a settings tab that allows you to choose Draft, Standard, Premium and Custom, 200 micron 70 micron! I can only set set Draft, Standard and Custom at 200 micron! what do I...
  4. Replies
    140
    Views
    190,801

    [ THING ] I was looking around for parts and modes for my...

    I was looking around for parts and modes for my EKO and was looking at your post and was considering doing this, but then I ran across one That gives me an option to actually print a replacement for...
  5. Replies
    481
    Views
    903,568

    Sticky: Thanks buddybu for the info I see if I can gather...

    Thanks buddybu for the info I see if I can gather up everything I need and getter done Saturday! Need sure if I can get it done this week end' had a death in the family and things are a little...
  6. Replies
    481
    Views
    903,568

    Sticky: Is there a Tutorial on that EKO to Cube3...

    Is there a Tutorial on that EKO to Cube3 conversion here
  7. Replies
    9
    Views
    5,939

    Thank you for your prompt reply and the wealth of...

    Thank you for your prompt reply and the wealth of information! The printer in ? I did try to flash the firmware when I got it but I believe the previous owner had tried and failed! But just a guess...
  8. Replies
    9
    Views
    5,939

    General Knowledge Questions

    Are all Cube cartridge chips the same? = as in part number , and would I be correct in assuming that only the onboard programing is different for each Cube system?

    On the motherboard, I read on a...
  9. Replies
    481
    Views
    903,568

    Sticky: New to This Game

    I just decided to try my hand at this 3D printing thing so I bought a couple of broken 3D Cube printers. I'm 70 and a retired Field Service Tech and i restore antique radios and other electronics for...
  10. Replies
    481
    Views
    903,568

    Sticky: Well downloaded the original firmware, patched...

    Well downloaded the original firmware, patched the firmware as instructed! Installed patched firmware! and all I have is a printer that print the test print! any ideas on this one

    - - - - - - - -...
Results 1 to 10 of 10