Search:

First off Tommy, please, could you remove/delete that dirty post ?

Getting back on my Cube not seeing the new magnetic surface, reversing it did not work. It is so shiny that the system shows an...

Thank you so much Tommy!
1:40 AM here... I will do more tests tomorrow and will post the results.
Have a nice weekend!

Tommy, I cannot remove the magnetic plate because now it is glued to the stock build plate.
What I was thinking that I can do is reversing the PEI layer so the grainy surface will be facing down....

Yes Doug!!
No glue, no blue tape, nothing... just the bare surface of the magnetic sheet.
As a plus, when the job is finished, you remove this layer, bend it and the prints are released very...

Hi Tommy, thank you for your reply!

Yes, I did so. Currently the Z-Gap is set to -2.418 and that may be OK but I am not absolutely sure it it is correct.
What is your Z-Gap with the glass...

Hola Marmii, buen día!

El diseño de razor81 parece ser la solución que estás buscando y creo que puede servirte.

Es muy difícil conseguir repuestos para esta impresora y menos aquí en...

Hi all!
I was looking to improve the adhesion to the build plate of my Cube 3 and, after reading a lot about different options and seeing what is available here in my Country, I decide to buy a...

Hi Doug, I just use the Cube Print 4.03 that came with the machine. I have not had the opportunity to try another slicer yet.

Hi Tommy!
I want to thank you very much for sharing this development and also encouraging other members to do it and take the advantage of using it.

I was thinking in a way to stabilize the build...

I think that, in my case, the problem is that the Teflon tube is quite soft and slippery.
I made the grooves in my lathe so they were perfectly parallel and 0.45 mm deep but the tube slips out...

I liked the battery holder! I will 3d print it to see the stitching in hand.
Thank you so much again!

Thank you very much TommyDee!

I will redesign the box taking in account all your suggestions and will print it so see what happen. I think that it will works.

Have a nice weekend!

I can understand what you are telling me TonnyDee, but actually these are not separate walls that I want to afix together.
These walls are created by the extrusor passing in parallel paths. I can...

The blue ring is just a slice of a 2x4 mm air polyamide tube with an axial cut (not shown) to let it be inserted on the other tube.
Unfortunately it slips out too. Although I liked very much the...

Hi all!

I am looking for some advise from you, experienced Cube3 users, to solve a problem that I have with my first design to be printed with my new machine.

I designed a little box in AutoCAD...

Report.
Well, the original filament in the stock cartridge definitely did not work at all. The new black filament that I bought was not so good, it cracks very easily so I went to buy the best...

Thank you so much to both of you for your quick reply! And yes, I was talking about those "cooling tower"... added to the vocabulary of my poor English!

Now I understood its function very well....

Hi TommyDee,
I am new to the forum and also a totally newbie to 3D printing.
First of all I want to thank you and all the other people who contribute for all these developments to solve the...