Search:

I found it. Its a 6 pic chip on the motherboard. Same chip on the board you would use to install a bootloader. I have a icsp micro programmer usb cable I'll use. Motherboard issues scare me. I had to...

Good idea. What kind of isp programming cable do you use on the CR10 motherboard? Isnt like a usb icsp pramming cable 6 pin? I see the firmware download is up on the creality site.

Split the file. Cut it into smaller sections using meshmixer or a similar program. Its the supports needed. Turns a small print to a very large print since it has to fill the open air with support...

I have a wierd issue. I had 5 cr10 printers all start having the same issue yesterday. It was raining outside and could have been a power surge. They all will heat up to 200 or whatever the print...

I found the issue. So on both printers the hot end fans were not blowing due to a blockage. One little peace of old filament on one and dust bonded together on the other. The issue was overheating...

Thanks for the reply. I have 2 printers its happening to. The CR10s is snapping outside the tube. But the filament inside the tube is really hard to pull out almost impossible.

- - - - - - - - - -...

Hi,

I'm having issue with my CR10S filament snapping mid print. Mutiple different filaments used with same issue. I've replace the bowden tube, cleaned the extruder , cleared any filament from the...

I had the same issue. I prurcahse a replacement bed pre wired from Creality for $45.