Search:

Type: Posts; User: daf

Search: Search took 0.00 seconds.

  1. Replies
    103
    Views
    76,250

    Broome Here is my calibration cube it has...

    Broome

    Here is my calibration cube it has patterning on all 3 walls but the front one as you can see
    even though the wall thickness was spot on .4mm so no fiddling with that.
    at this point I...
  2. Replies
    103
    Views
    76,250

    CrazyCoder...

    CrazyCoder


    Just a thought what about swapping your extruder stepper motor with one of the X wing motors ?


    I think they are the same units that could then give you a yes or no if its the...
  3. Replies
    103
    Views
    76,250

    Have you checked the wiring is not compromised...

    Have you checked the wiring is not compromised inside of the serial connector as one other has found a wire was squashed and had broken strands inside which directly effected his extruder stepper...
  4. Replies
    103
    Views
    76,250

    oh another thing to try is slicing with different...

    oh another thing to try is slicing with different software and see if you still get the pattern ....
    different slicers can change this.
  5. Replies
    103
    Views
    76,250

    CrazyCoder...

    CrazyCoder

    Hi I am wondering if the tension on your extruder stepper is too much then the ribbing on the wheel will chew into the filament which would then feed down into extrusion ??? try...
Results 1 to 5 of 5