Search:

Type: Posts; User: Nick

Search: Search took 0.00 seconds.

  1. I found it. Its a 6 pic chip on the motherboard....

    I found it. Its a 6 pic chip on the motherboard. Same chip on the board you would use to install a bootloader. I have a icsp micro programmer usb cable I'll use. Motherboard issues scare me. I had to...
  2. Good idea. What kind of isp programming cable do...

    Good idea. What kind of isp programming cable do you use on the CR10 motherboard? Isnt like a usb icsp pramming cable 6 pin? I see the firmware download is up on the creality site.
  3. Thread: New to this!!!!

    by Nick
    Replies
    4
    Views
    2,906

    Split the file. Cut it into smaller sections...

    Split the file. Cut it into smaller sections using meshmixer or a similar program. Its the supports needed. Turns a small print to a very large print since it has to fill the open air with support...
  4. Nozzle temperature issue? Heating to 200 then clears to 0 on LCD

    I have a wierd issue. I had 5 cr10 printers all start having the same issue yesterday. It was raining outside and could have been a power surge. They all will heat up to 200 or whatever the print...
  5. Replies
    5
    Views
    5,771

    I found the issue. So on both printers the hot...

    I found the issue. So on both printers the hot end fans were not blowing due to a blockage. One little peace of old filament on one and dust bonded together on the other. The issue was overheating...
  6. Replies
    5
    Views
    5,771

    Thanks for the reply. I have 2 printers its...

    Thanks for the reply. I have 2 printers its happening to. The CR10s is snapping outside the tube. But the filament inside the tube is really hard to pull out almost impossible.

    - - - - - - - - - -...
  7. Replies
    5
    Views
    5,771

    3 d filament snapping mid print

    Hi,

    I'm having issue with my CR10S filament snapping mid print. Mutiple different filaments used with same issue. I've replace the bowden tube, cleaned the extruder , cleared any filament from the...
  8. Replies
    2
    Views
    3,580

    I had the same issue. I prurcahse a replacement...

    I had the same issue. I prurcahse a replacement bed pre wired from Creality for $45.
Results 1 to 8 of 8