Search:

Type: Posts; User: rassilon50

Search: Search took 0.00 seconds.

  1. Replies
    34
    Views
    324,584

    That did it! Thank you!

    That did it! Thank you!
  2. Replies
    34
    Views
    324,584

    I've got the cube-utils (which I've been happily...

    I've got the cube-utils (which I've been happily using in windows) but I also use a MAC and cannot for the life of me get it work.

    I've installed the build tools for Mac.

    I've run the commands...
  3. Replies
    141
    Views
    573,693

    Sticky: Sadly the CubePro has ALWAYS vibrated itself...

    Sadly the CubePro has ALWAYS vibrated itself stupid, when using its own software and filament. Always sounded like it was going to shake itself off the table! But I've never noticed this effect...
  4. Replies
    141
    Views
    573,693

    Sticky: Hi Tommy, Thanks for that. What's happening...

    Hi Tommy,

    Thanks for that.

    What's happening is I am experiencing Ringing / Ghosting - https://rigid.ink/pages/ultimate-troubleshooting-guide#issue-vibrations-and-3d-printing-ringing-31

    And...
  5. Replies
    141
    Views
    573,693

    Sticky: Hi Guys, I don't support there's any clues as...

    Hi Guys,

    I don't support there's any clues as to the acceleration and jerk settings in the GCODE is sthere?
  6. Replies
    483
    Views
    983,935

    Sticky: Just wanted to say thank you! Very much...

    Just wanted to say thank you! Very much appreciated.
  7. Replies
    2
    Views
    4,706

    It varies, even if I seem to print the same file...

    It varies, even if I seem to print the same file twice.

    I think its partly over extruding, under / over speeding etc. If I print a file using the CubePro software, whilst not perfect it does print...
  8. Replies
    2
    Views
    4,706

    CubePro - Simplify3D Settings - PLA

    Hey all, sorry if this is in the wrong part.

    I've recently liberated my CubePro using the Firmware Hack - Yaaay

    I can now use Filament from other places - Yaaay

    I use Simplify 3D as a...
  9. Replies
    34
    Views
    324,584

    I don't suppose anyone made any progress on a...

    I don't suppose anyone made any progress on a .cubepro decoder did they? I'm trying to work out the right settings for PLA and it's driving me nuts.
  10. Replies
    483
    Views
    983,935

    Sticky: Hi everyone, Does anyone happen to have a...

    Hi everyone,

    Does anyone happen to have a copy of the 2.00 firmware for the CubePro? Or better yet the already hacked version?

    The link at the beginning of the blog doesn't seem to work any...
Results 1 to 10 of 10