Search:

This is my Rapide lite 200 with modified 312 bed and e3dv6 extrusor (bowden).

I re-designed the extrusor head to use a radial fan for bed and a 4cmx4cmx2cm fan. :)

2080 2081

I'm now using a...

Finally I done :-)

Was one of the Z DRV8825. I was defective. I removed it and put all two motors on the other DRV and all work now.

Ty for suggestions.

I found the error. I forgot to change jumpers under DRV8825 to 32 steps. Now they works all excepting Z motors. They are 32 steps too?

I put the two motors on Z and E1 as...

It make a noise and move a bit. In some case with Y I successful moved by 1 mm, but only for some steps. With Y and Z nothing, only noice and vibration.

I have some troubles with motors after board change.

when I send a command to move by 1 mm I got a try from printer but it remain in actual position.

I forgot something?

1490

I set...

Hi there,
i'm changing the board and I have some doubts about End stops cable connections.

In original board we have 2 pins, in rumba 3 pins.
I suppose blue cable is ground and colored is...

yep, with another board it works :-)

I think so :/

In that case I have to change whole board or there is some trick to fix USB?

thank you for helping

No, I use a laptop with windows 7 only for 3d printing and nothing is changed there.
I tried another PC but same result :/

I printed with my Rapide 200 a lot of models for months.

Today something happens: printer and PC do not comminicate more (Windows).
SD card works perfecty as before.

I changed PC, changed...

56 and 190-205 (different test)

I was meaning I don't need to create a large surface, but only small pieces 1-2 cm wide. Not reffering to the tall of the top :-)

Anyone successfull made a smooth top surface?
I mean also something very little.

I got that with Ultimaker 2 without problems many times in the past, but with Rapide Lite 200 I cannot. I have...

solved. thanks :-)

I successfull calibrated the Z axis, but every time I try to print with Repietier Host the printed try to move on X-axis over the limit for some seconds beating the printer border. After some...