Search:

Type: Posts; User: rlb245

Search: Search took 0.00 seconds.

  1. Replies
    10
    Views
    4,109

    Well sir you're absolutely right on that one...

    Well sir you're absolutely right on that one Tommy! Was looking at the bios! From what I can see no support! Sorry for the late reply but I was in Seattle all winter working and sense I've been...
  2. Replies
    10
    Views
    4,109

    Thanks Tommy for the reply! I probably should...

    Thanks Tommy for the reply! I probably should have told you up front that it's a EKO! but I recalibrated the unit and sent the table cap with a piece of paper and everything is working really nice...
  3. Replies
    10
    Views
    4,109

    The Cubify Print program has a settings tab that...

    The Cubify Print program has a settings tab that allows you to choose Draft, Standard, Premium and Custom, 200 micron 70 micron! I can only set set Draft, Standard and Custom at 200 micron! what do I...
  4. Replies
    140
    Views
    114,315

    [ THING ] I was looking around for parts and modes for my...

    I was looking around for parts and modes for my EKO and was looking at your post and was considering doing this, but then I ran across one That gives me an option to actually print a replacement for...
  5. Replies
    480
    Views
    540,928

    Sticky: Thanks buddybu for the info I see if I can gather...

    Thanks buddybu for the info I see if I can gather up everything I need and getter done Saturday! Need sure if I can get it done this week end' had a death in the family and things are a little...
  6. Replies
    480
    Views
    540,928

    Sticky: Is there a Tutorial on that EKO to Cube3...

    Is there a Tutorial on that EKO to Cube3 conversion here
  7. Replies
    10
    Views
    4,109

    Thank you for your prompt reply and the wealth of...

    Thank you for your prompt reply and the wealth of information! The printer in ? I did try to flash the firmware when I got it but I believe the previous owner had tried and failed! But just a guess...
  8. Replies
    10
    Views
    4,109

    General Knowledge Questions

    Are all Cube cartridge chips the same? = as in part number , and would I be correct in assuming that only the onboard programing is different for each Cube system?

    On the motherboard, I read on a...
  9. Replies
    480
    Views
    540,928

    Sticky: New to This Game

    I just decided to try my hand at this 3D printing thing so I bought a couple of broken 3D Cube printers. I'm 70 and a retired Field Service Tech and i restore antique radios and other electronics for...
  10. Replies
    480
    Views
    540,928

    Sticky: Well downloaded the original firmware, patched...

    Well downloaded the original firmware, patched the firmware as instructed! Installed patched firmware! and all I have is a printer that print the test print! any ideas on this one

    - - - - - - - -...
Results 1 to 10 of 10