Search:

Type: Posts; User: Tfactor

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    729

    Quick update. I've measured my extrusion rate and...

    Quick update. I've measured my extrusion rate and it was 2.04% slower. So I've increased the flow rate in Cura to compensate for it.
    Here is the result:
    3271


    I'll reprint the statue and see...
  2. Replies
    11
    Views
    729

    There is no auto leveling with this machine. Are...

    There is no auto leveling with this machine. Are you talking about that line running vertical up the side of the cube? If yes, that's an indentation at where the infill meets the wall... only...
  3. Replies
    11
    Views
    729

    Well I've printed 2x20mm cubes, one of them was...

    Well I've printed 2x20mm cubes, one of them was in the middle of the build plate the other in the bottom right corner. There are some visual flaws with them so let me know what you guys think!
    ...
  4. Replies
    11
    Views
    729

    Hi! Thanks for your reply! I've tried those...

    Hi! Thanks for your reply! I've tried those settings and there was a little bit of improvement but the cape stayed about the same.
    Not sure what your question is about the hardware. I've reveled...
  5. Replies
    11
    Views
    729

    Identify the cause of this artifact.

    Hi all, recently got a cr10s and overall the prints are nice but I can't seem to get rid of this artifact. Print is 8cm tall and used these settings:
    0.4mm nozzle
    60mm/s print speed
    0.15mm layer...
Results 1 to 5 of 5