Search:

Does the Titan extrude any smoother?
Although I am very happy with how my Rapidelite prints I do get some minor moire effect on flat sides, had been wondering if it was from extruder steps & if the...

Haven't tried the Aurarum TPE but I have been using Blueprinted 3D TPU & it prints really well, not sure if its as rubbery though.

Up the road, CBC in Adelaide, but any bearing place could get them.

I have replaced all the bearings in my printer with better quality units from a local bearing supplier (in Australia), cost over $16 each, a lot more expensive than the $1 ones online.
The Y axis is...

I couldn't find any proportions anywhere, doesn't seem too critical, I put approx 200ml acetone in a jar & I guess roughly 10 pieces of ABS about 5cm long should be enough, just ends up looking like...

The only way I have had any success getting ABS to stick is using ABS juice, which is acetone with a few bits of ABS dissolved in it. Just dip a tissue in it & wipe it over the bed (I am using Kapton...

Im another one who has had this issue, was printing fine for days then it started the clicking & poor feed of the filament.
What fixed mine was just tightening the grub screw that holds the heating...