Search:

Type: Posts; User: gadavis99

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    3,018

    For visualizing gcode - there are a bunch out...

    For visualizing gcode - there are a bunch out there - the one I happen to have bookmarked is http://gcode.ws/ - it is pretty fast and stable.
    After looking at your tests, it makes me wonder if it...
  2. Replies
    6
    Views
    3,018

    Ah - I haven't tried looking at them in CubePro. ...

    Ah - I haven't tried looking at them in CubePro. I just used the little decoder utility that someone wrote to extract the gcode, and looked at it with a viewer that runs in web browser.
    Seconding...
  3. Replies
    6
    Views
    3,018

    Infill pattern oddness

    So, I finally tried extracting gcode from a Cube software generated file. I'm a teacher, and am having the students compare output from a Cube 3 with a FlashForge Dreamer (some groups are making...
  4. Replies
    334
    Views
    922,138

    Sticky: I need a first gen cartridge - the ones that go...

    I need a first gen cartridge - the ones that go with the v1 printer (single head, ABS only, heated bed, etc.). I got one that was being retired, but no carts - was going to feed it via bulk, but it...
  5. Replies
    334
    Views
    922,138

    Sticky: Looking for - chip from v1 Cube cartridge. I got...

    Looking for - chip from v1 Cube cartridge. I got my hands on an old v1 Cube, but all of the used cartridges got discarded. I just need one of the chips so I can get it to start jobs and run from...
  6. Replies
    64
    Views
    41,249

    Yes, both of mine made a lot of pock-marks and...

    Yes, both of mine made a lot of pock-marks and scrapes on their build plates before I manually set the gap a touch larger than the 'auto' setting :(. I have patched my partially delaminated plate...
  7. Replies
    64
    Views
    41,249

    Aftermarket build plate?

    Anyone have any luck with build plate replacements other than from 3DS? I had my first plate failure, with ABS sidewalks pulling up the alumina surface :( The $99 replacements are harsh, and I have...
  8. Replies
    2
    Views
    4,436

    How to quiet during printing?

    So, now that there are options for low-cost filament (thanks, firmware crackers!), I'm planning on using my Cube3's more. However, they are so loud when running, it is a major distraction in my...
Results 1 to 8 of 8