Search:

Type: Posts; User: sukhvir

Search: Search took 0.00 seconds.

  1. Replies
    41
    Views
    43,636

    Hi acnow. I have used Meshmixer and although...

    Hi acnow. I have used Meshmixer and although good, needs a lot of tweaking. One of the things I would stress is to make sure the support is a good distance away from the print (MM only allows 0.5mm...
  2. Replies
    41
    Views
    43,636

    @AngryPanda, I have been testing the FTD resin...

    @AngryPanda, I have been testing the FTD resin and the results so far have been very positive. The MJ G+ resin compares very poorly to FTD in ALL areas. Please see my main points below:

    - FTD has...
  3. Replies
    41
    Views
    43,636

    The MJ SF resin is meant to be better than G+ and...

    The MJ SF resin is meant to be better than G+ and TOW said SF does work, though they have only done a couple of prints with it.

    I am awaiting FTD resin and hope I have better luck with that...
  4. Replies
    41
    Views
    43,636

    I carried out another test print and have...

    I carried out another test print and have attached the results. I tried to change the orientation of the print as suggested, however ALL of my prints seem to be failing in a similar fashion. If the...
  5. Replies
    41
    Views
    43,636

    Thanks woale. I appreciate the feedback. I have...

    Thanks woale. I appreciate the feedback. I have ordered some Fun To Do resin and their quality seems far better. Also, I'm going to try rotating on X and Y axis to see how it affects results.

    I...
  6. Replies
    41
    Views
    43,636

    I decreased it to 35000, however found some...

    I decreased it to 35000, however found some layers in between didn't cure properly. Increased it to 45000 and got better results.

    I've decided to change resin and have ordered some FunToDo resin...
  7. Replies
    41
    Views
    43,636

    Sounds like a plan. I emptied resin into a...

    Sounds like a plan. I emptied resin into a container, strained out the rubbish, shook and poured back in (I'm not rich enough to waste resin :))

    Starting another print and have also reduced...
  8. Replies
    41
    Views
    43,636

    This print was done a couple of days ago. The...

    This print was done a couple of days ago. The team ran a smaller print test when they were here to calibrate resin etc. The test print I gave them broke into pieces when trying to remove from build...
  9. Replies
    41
    Views
    43,636

    The OWL works team shook the bottle vigorously...

    The OWL works team shook the bottle vigorously before putting in the resin @bolsoncerrado. The issue with the print is that the upper layer seems fine, but the bottom layer is bumpy and softer. Print...
  10. Replies
    41
    Views
    43,636

    Great thread guys and hopefully we can fine tune...

    Great thread guys and hopefully we can fine tune the settings to get better prints. Attached is my failed print. Is this a result of undercuring? Also, what resin are you using woale? I have MJ G+...
Results 1 to 10 of 10