Search:

Type: Posts; User: Cubical

Search: Search took 0.00 seconds.

  1. Small update to this -- in the extruder I had...

    Small update to this -- in the extruder I had opened the gap all the way up, I switched to a different filament (nylon) and it no longer would feed reliably, probably because nylon is a bit slippery....
  2. Did you try taking the feed section of the...

    Did you try taking the feed section of the extruder apart? Remove four hex bolts and the two pieces of the feed unit pull apart. I had filament get wrapped around the feed wheel. By taking it...
Results 1 to 2 of 2