Search:

Well sir you're absolutely right on that one Tommy! Was looking at the bios! From what I can see no support! Sorry for the late reply but I was in Seattle all winter working and sense I've been...

Thanks Tommy for the reply! I probably should have told you up front that it's a EKO! but I recalibrated the unit and sent the table cap with a piece of paper and everything is working really nice...

The Cubify Print program has a settings tab that allows you to choose Draft, Standard, Premium and Custom, 200 micron 70 micron! I can only set set Draft, Standard and Custom at 200 micron! what do I...

I was looking around for parts and modes for my EKO and was looking at your post and was considering doing this, but then I ran across one That gives me an option to actually print a replacement for...

Thanks buddybu for the info I see if I can gather up everything I need and getter done Saturday! Need sure if I can get it done this week end' had a death in the family and things are a little...

Is there a Tutorial on that EKO to Cube3 conversion here

Thank you for your prompt reply and the wealth of information! The printer in ? I did try to flash the firmware when I got it but I believe the previous owner had tried and failed! But just a guess...

Are all Cube cartridge chips the same? = as in part number , and would I be correct in assuming that only the onboard programing is different for each Cube system?

On the motherboard, I read on a...

I just decided to try my hand at this 3D printing thing so I bought a couple of broken 3D Cube printers. I'm 70 and a retired Field Service Tech and i restore antique radios and other electronics for...

Well downloaded the original firmware, patched the firmware as instructed! Installed patched firmware! and all I have is a printer that print the test print! any ideas on this one

- - - - - - - -...