Search:

Any news on this topic? Are those helpful to Cartesian RL200?

So quality won't be affected for cartesian DRV8825's? No need to buy?

This is the latest Marlin 1.1.0 RC6+RCBugfix (06 May 2016): 1450
Full GLCD, Manual&Mesh Bed Leveling, AutoPID menu, Babystepping and filament change are enabled.

But you need to physically move...

I also don't know why it's there. Z_MAX Endstop is more important I think.

Anybody to have CAD model of V2 and V3 extruder for Rapide Lite 200?

I think you can't directly configure that, but you can first try editing pin_RUMBA file to share tool0 temp pin for other tools. If that not work, you should go deep into coding about LCD or temp...

That's really great Clayton, good job. Can you find an appropriate connector to fuse two Z motor cables into one?

I_TripMax = Peak current through one winding of your motor (A)(other winding will be off). Note that the current rating shown on your stepper motor is usually for current in both windings. The peak...

http://www.bbc.com/news/technology-35060123

Thanks for the video Justin.

Today I want to set my stepper driver's VREF so I researched a little. I see that VREF calculation for DRV8825 is: I_TripMax= Vref/(5*Rs)...

Can't we do this(Assuming you have a second Arduino board): https://www.arduino.cc/en/Tutorial/ArduinoISP

Ozgun Can OZGUNES, Ankara - TURKEY, 1xMaterialize Me Pro perk, $100

It'll okay, but you can find cheaper prices on same item at ebay.

@milstream, it would be great if you can share the 3d model of Rapide Lite?

You can edit .ini files at Cura folder for non-um machines, but software is broken generally.

..and all-new problems.

I asked Ethan two times for ATmega16 DFU mode and flash issues. First he said he forwarded it to Chinese engineers but no answer has come to me, no answer came to the second one.

Your model is good SAO, physics is the troublemaker ;).

BTW, I've seen lots of nozzle fan design over Thingiverse, but I think best fan setup is Ultimaker 2's, we can simulate it with two big wide...

If I had time, I will definitely run a simulation of airflow, but currently I can't do it.

I think we don't need 360deg holes, just 2 big holes front(a bit smaller) and back(a bit bigger). Because...

Can you try this without scaling: http://www.thingiverse.com/thing:215703/#files

Overhangs become worse and edges become rough with nozzle fan.

I'm printing PLA. I used your fan Bobenham.

I was trying to print 3DHubs Marvis test print at small scale(2 cm^3). With Pro version fan, it came really rough because of interlayer warping everywhere. I tried 3-4 prints and all was same. Then I...

I used nozzle fan and see that it decreases print quality. Because it can't put enough air to nozzle tip. Most of air goes to upward(which is bad for heat-block) and some air creates resistance to...

Yes, it is right, %90 is suggested for a little bit more elongation without break.

http://my3dmatter.com/influence-infill-layer-height-pattern/