Search:

Have a look at the activation site -http://infocenter.3dsystems.com/cubepro/user-guide/unpacking-and-setting-your-cubepro/setup-and-activation
A 4 digit pin is generated based on the serial number,...

The main PWB is the same and all the components are there so i am guessing that it would be upgradeable but not without the right activation code or a firmware hack (Beyond my capabilities). I tried...

Hi Tommy, I finally got some parts and tried the conversion, even with the all the parts it will only let you load number 1 with filament, interesting when filament is in other stations the Cubepro...

The head PWB has the connectors for 2 additional extruders and nozzles, the motherboard also has the additional connectors for cartridge bays 2 and 3 EPROM readers.
Looking at the Cubepro parts...

Thanks for your prompt reply Tommy.
From what I can make out there is just a lead from the main board to the cartridge holder, the cartridge holder then has two contacts that supply power to and...

I have a Cubepro single which I would like to update to a duo or trio. As all the feed tubes are already in place it looks like all that is needed is the cartridge holder (Though this does not seem...