Search:

I looked at http://www.print3dforum.com/showthread.php/26-3D-Software-settings-for-Rapide-Lite but for those values what quality should I expect, draft, high-precision? What parameters do you change...

Why are there two springs to control how tight the wheels press the filament? Why not just one?

How do you tighten them - for example: which one first?

@grobbins Thanks for digging for the other picture! Now we only need to know where the two pairs of wires are connected (at the other end) on the PCB. :P :(

If someone with the fans working...

After you connect the printer to the computer you can see a new device:


$ ls -l /dev/ttyACM0
crw-rw---- 1 root uucp 166, 0 Jan 12 08:07 /dev/ttyACM0
$ ls -l /dev/serial/by-id/
lrwxrwxrwx 1...

Some pictures I took while switching the fans. The cables were long enough.

365

366

367

Ethan said it was a production line issue where the fans were place incorrectly and that I don't need to change the cables or anything like that, only switch the fans. Seems easiest to do anyway,...

Do we know where exactly the bad connection is:
A. The PCB's connection to the wire.
B. The wire's connection to the extruder (the connector which looks like a PC serial port).
C. In the extruder...

You could try with a different computer, then you might know whether to blame the computer or the printer/cable.

If I go to http://www.print3dforum.com/forum.php the first section (Rapide 3D) has a broken image on the left side.

This thread is about the Cura settings, please start a new thread if you did not find anything.

@daf Please edit the top post and mention the source of the info. Thanks!

Daf, how exactly did you obtain those settings? Thanks!

https://www.youtube.com/watch?v=yYpwbZsvpyQ

Some pictures on how to reassemble the extruder. I see others have the case made of aluminium. Mine must be an early experimental version or something.. :(

268

269

270

271

Thanks! I did not even notice there is a left-limit-switch which can be moved. Works better now. I'm looking how to calibrate the thing.

I try to print with Cura, but when the printing starts, the nozzle (A) moves to the front-left and goes down and then it hits the front-left screw (B) of the bed. I already switched the screw (B)...