Search:

Type: Posts; User: MegaloDon

Search: Search took 0.00 seconds.

  1. Replies
    65
    Views
    6,229

    https://support.3dsystems.com/s/article/Cube-3-Eko...

    https://support.3dsystems.com/s/article/Cube-3-Ekocycle-Best-Practices

    For a good z-gap, you should be able to slide through the gap gauge (from your tools) between the print tip and print pad,...
  2. Replies
    65
    Views
    6,229

    From here >>>...

    From here >>> http://www.print3dforum.com/showthread.php/900-Cube3-Filament-*SOFTWARE*-Hack-is-here!!!?p=43316&viewfull=1#post43316
    "Secret" to me indicates that it is not documented. This is not a...
  3. Replies
    65
    Views
    6,229

    I don't think the problem is with G70. TD has...

    I don't think the problem is with G70. TD has his own opinions on things and thinks his ideas are the only good ones. G70 was simply stating facts and got a sarcastic response. There is no reason...
  4. Replies
    65
    Views
    6,229

    Whether you're using LokBuild or stock build...

    Whether you're using LokBuild or stock build plate, auto-gap has never been consistent. It's always best to do a manual gap. And the hidden Cal2 button helps to make sure the head never hits the...
  5. Replies
    65
    Views
    6,229

    Be careful! It says to use LOW isopropyl when...

    Be careful! It says to use LOW isopropyl when using isopropyl alcohol.
  6. Replies
    65
    Views
    6,229

    That's why hair dryers use magnets for safety...

    That's why hair dryers use magnets for safety shutoff switch.
  7. Replies
    65
    Views
    6,229

    I always set mine manually with the included gap...

    I always set mine manually with the included gap gauge too. The automatic is too inconsistent.

    Tom,
    I didn't know about this setting either. I read the manual (if at first you don't succeed,...
  8. Replies
    65
    Views
    6,229

    Where is this setting?

    Where is this setting?
Results 1 to 8 of 8