Search:

Type: Posts; User: michel

Search: Search took 0.00 seconds.

  1. Replies
    28
    Views
    31,330

    [ HOW TO ] Thanks for all these informations. Of course...

    Thanks for all these informations.
    Of course puting the printer under a cover is a good idea.
    Did I understand well : you put Marlin as a firmware for that cube? I knew Marlin for MEGA + RAMPS...
  2. Replies
    28
    Views
    31,330

    [ HOW TO ] Thanks a lot Buddybu !! This evening, I made a...

    Thanks a lot Buddybu !!
    This evening, I made a print with ABS without heated bed and without glue. I used a painter's masking tape. Scotch blue....(you know certainly).
    Finaly, it worked fine. But...
  3. Replies
    28
    Views
    31,330

    [ HOW TO ] Hi Razor81, Thanks for you reply....but I'm new...

    Hi Razor81,
    Thanks for you reply....but I'm new on that forum and unable to find the Kiza'thread or yours.
    Try to search with Kiza or Razor81...but not successfull.
    Have you a link? Thanks in...
  4. Replies
    28
    Views
    31,330

    [ HOW TO ] Hello Dougk 12 To print with ABS, the...

    Hello Dougk 12
    To print with ABS, the temperature must be around 90 ° C = 194 ° F .... so, not very far from 225 ° F!
    The "temperature regulation" component is not very difficult to make with an...
  5. Replies
    28
    Views
    31,330

    [ HOW TO ] heated bed for cube3D

    Hi Everyone,

    sorry for my bad English...I'm French...Nobody is perfect !
    I would like to know if anyone has tried to fit a heat bed on the printing plate of this printer.

    Will this have an...
Results 1 to 5 of 5