Search:

Type: Posts; User: onthuhlist

Search: Search took 0.00 seconds.

  1. Replies
    334
    Views
    923,451

    Sticky: I have a Cube 3, not a Cube Pro. So is this...

    I have a Cube 3, not a Cube Pro. So is this reservation about the hack not a worry for the Cube 3?
  2. Replies
    334
    Views
    923,451

    Sticky: TommyDee, first - Thanks so much for your input....

    TommyDee, first - Thanks so much for your input. I have a few more questions and then I think I'm good.

    1. Can the chips be initialized (set from 100% to 99%) via the ReCube devices, or must they...
  3. Replies
    334
    Views
    923,451

    Sticky: TommyDee, is that caveat on the printer firmware,...

    TommyDee, is that caveat on the printer firmware, or are you talking about the chips? Must the chips be initialized (<100%) in order to reprogram them with the ReCubePro (assuming I send them to...
  4. Thread: Mistake?

    by onthuhlist
    Replies
    16
    Views
    12,231

    So now I have a slough of questions for you. 1....

    So now I have a slough of questions for you.
    1. Do I understand correctly that you have the default gap so wide that you cannot auto-level your plate? Or is it close enough to auto level? 2. To...
  5. Thread: Mistake?

    by onthuhlist
    Replies
    16
    Views
    12,231

    Thanks guys. I just had an idea; I tend to use...

    Thanks guys. I just had an idea; I tend to use 3D-Fuel Pro PLA most of the time anyway. It has some ABS-like properties without the fumes, and I often extrude it at 220-230 deg C. Does anyone know...
  6. Thread: Mistake?

    by onthuhlist
    Replies
    16
    Views
    12,231

    Thabks TommyDee. If folks like you are passionate...

    Thabks TommyDee. If folks like you are passionate about this, it may be worthwhile to persevere. I need to redo my Ender 3 bed also so maybe I can kill 2 birds with 1 stone.
  7. Thread: Mistake?

    by onthuhlist
    Replies
    16
    Views
    12,231

    Mistake?

    Beginning to think it was a mistake to pick up a used Cube 3. The auto level works, but not the auto gap. To get the auto level to work, I had to do a fair amount of sanding on the bed. Still has...
  8. Replies
    334
    Views
    923,451

    Sticky: Thanks TommyDee. Does the universal hub require...

    Thanks TommyDee. Does the universal hub require you to wrap your own filament on the Cube 3 cartridge?

    You mentioned code change with caveat. This code change?...
  9. Replies
    334
    Views
    923,451

    Sticky: So I just picked up a used Cube 3 for $50 to see...

    So I just picked up a used Cube 3 for $50 to see if I could convert it to bulk filament. Unfortunately it came with only an ABS cartridge (which I am told is unused) with teal color filament. I plan...
Results 1 to 9 of 9