-
Cube Print Temperature Modifier *beta*
Last edited by Mythandar; 06-07-2018 at 04:03 AM.
-
Post Thanks / Like - 3 Thanks, 5 Likes, 0 Dislikes
-
Administrator
I was onsidering getting a few of these:
https://www.amazon.es/vovotrade-Wate...X5679WHKZDT2FM
to leave them permanently attached to the Cube (not glued, just so small they are almost invisible
) with the .cube3 "commands" like an extension of the firmware/menus on the Cube...
Wdy think?
-
Connect a Pi3 to the other USB port and have it snoop around
-
Administrator
duH!? connect how? I mean I know the physical plug, whats next? ssh?
-
Can you run windows 10 on Pi3 or is there a 3D Builder app for Pi3? I guess that's Android?
- - - - - - - - - -
Technically, the printer is a specific device. If you know how to hack devices from their USB port, you can go to town.
I still think that the communication layer and the proprietary hardware layer are superfluous.
There is a hardware layer that we should be able to hack into with some hardware and a real brain.
-
There is a Windows 10 version for the Pi3 but it's not great. The Pi is an ARM processor and "built" for Linux based distributions. All of the official Raspberry Pi OSes are Linux variants. There was an android port but it's so slow it's not worth it
-
If it meets 3D Builder's OpenGL requirement, it may run.
We have 3DS drivers for that -and- their ABS implementation with their rafts is quite nice!
And you can remote your workstation. Talk about standalone 
I have the Lenovo YogaBook in the Windows 10 version. It handles 3D Builder nicely.
-
Administrator
What is 3DBuilder able to do once communicating with the Cube?
-
Set up a print plate and send it to the 3DS print spooler.
You can also save the build plate, but not the print settings.
And the print settings in the 3DS driver lie.
The driver implementation requires physical handshaking with the printer.
Otherwise it defaults to a garbled RAW print file.
-
PETG on the Cube 3!!
http://www.print3dforum.com/showthre...ll=1#post41792
- - - - - - - - - -
More results in PETG.
http://www.print3dforum.com/showthre...ll=1#post41767
- - - - - - - - - -
Does this work with dual color as well?