Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 6 of 6
  1. #1
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    2,935
    Post Thanks / Like

    Weird filament coming out of the Cube....

    So i've been experiencing this issue with a particular Cube and a particular spool of filament...





    First I cleaned up the nozzle as much as I could and reinstalled (left). Same issue.

    Then I installed a different nozzle (clean one, on the right). Same issue.


    As you can (sort of) see here, filament comes out "sparkling", aka full of .... holes? brittle?!



    (PFTE just added for autofocus sake!)


    So where I reside there's not that much humidity and I've faced this issue after 3yr+ of printing, so I don't think its due to humidity, but I still need to try with a different spool.


    Just wanted to hear opinions on it?


    Ideas?


    Thanks!

  2. #2
    3D Printer God(dess)
    Join Date
    Nov 2016
    Posts
    1,051
    Post Thanks / Like
    Is the filament particularly hard to feed through the driver cogs?

    This is what my silver WYZ filament did... and strained the heck out of the driver motor.
    That is where the modified cog came from.

  3. #3
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    2,935
    Post Thanks / Like
    Not particularly this one, no. It feeds normal but behaves weird on the exit. Anyhow I just tried another spool and it's ok now. Wotta weirdo.

  4. #4
    3D Printer Noob
    Join Date
    Feb 2017
    Posts
    7
    Post Thanks / Like
    I have a roll of PLA from MakerGeeks that does the same thing on my Anet A8. Was going to try to stick it in the oven for a while to see if it needed to be dried out but it was like this straight out of a vacuum sealed bag from the manufacture.

  5. #5
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    2,935
    Post Thanks / Like
    Perhaps its true and it got too much moisture although as I said ive had older spools than this (this may have 6mo since opened and i've had 3yo spools open printing without issues) but each brand, each spool is unique, as it seems.

  6. #6
    3D Printer God(dess)
    Join Date
    Nov 2016
    Posts
    1,051
    Post Thanks / Like
    They cannot suck up that much moisture.
    There is a limit where the material is considered "saturated".

    Call it what it is... junk.
    I always call for refunds when people send me junk.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •