Thanks Thanks:  0
Likes Likes:  2
Dislikes Dislikes:  3
Page 2 of 2 FirstFirst 12
Results 11 to 15 of 15

Thread: Blob Shield

  1. #11
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    2,826
    Post Thanks / Like
    Which filament is that?

  2. #12
    3D Printer Noob
    Join Date
    Aug 2017
    Posts
    4
    Post Thanks / Like
    Quote Originally Posted by bolsoncerrado View Post
    Which filament is that?
    It is the filament from cube self, but the printer gives these dots during the print. It stops for a second on the place where the dots are and than it goes further.

  3. #13
    Expert 3D Printer
    Join Date
    Jan 2017
    Posts
    398
    Post Thanks / Like
    Quote Originally Posted by Pink View Post
    It is the filament from cube self, but the printer gives these dots during the print. It stops for a second on the place where the dots are and than it goes further.
    I haven't seen that particular issue. Can you link the STL? (or does it happen on all STL's)

  4. #14
    3D Printer Noob
    Join Date
    Aug 2017
    Posts
    4
    Post Thanks / Like
    It does it on all stl's but is not that much aneymore?

  5. #15
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    2,826
    Post Thanks / Like
    Perhaps moisture on your PLA....

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •