Did you crack it while trying to open it? I told you the resin is VERY BRITTLE but you can't probably break it with your bare fingers. The fun of this part is heat resistance. Once you create the complete nozzle, you don't need to open it unless you get a clog, and with the reworked bowden you shouldnt have clogs.
MegaloDon, would you mind sharing your design? We need a solution urgently. Even if just to test this concept. We have various Cube3's and the filament cartridge breakage just gets worse by the day. We also have some ASA material I would like to try the print with.
It has already been shared here. >>> http://www.print3dforum.com/showthre...ll=1#post42476
Just print it in ABS and it should be fine.
I did not use it, I opened it at the top and ok, but when I put the spring the piece left and it went off with the spring ... I have not had time neither to release nor to use ..
I think you can remove the washer and put a piece of pipe and thus make the walls of the mouthpiece thick and strong ..
We'll need to sort out a replacement sooner or later....
[Quote = bolsoncerrado; 43474] Vamos a tener que solucionar un reemplazo, tarde o temprano .... [/ quote]
I printed this nozzle in nylonstrong and it is very hard and strong at temperatures .. it is like a stone ... I printed many abs reels without problems ..
WhatsApp Image 2018-01-11 at 10.06.41.jpg
Which printer did you use to print in nylon?