Thanks Thanks:  2
Likes Likes:  5
Dislikes Dislikes:  0
Page 3 of 3 FirstFirst 123
Results 21 to 23 of 23
  1. #21
    3D Printer God(dess)
    Join Date
    Nov 2016
    Posts
    1,058
    Post Thanks / Like
    Finally got the time to make Marvin with wash-away filament.

    The Good... it does work. Even the cartridge I got a year ago went right to work... and with a 100% cartridge no less!

    The Bad... doesn't even think about sticking to LokBuild! A little Cube Glue solved that.

    The Ugly... see below.

    Not any issues with the Inf filament other than needing a serious soaking and scrubbing.
    Just the mess dual extruder printing can make unless you tend every layer.
    This is mostly due to the fact that my wipers are not at the right level under the print-head.

    marvin in ice.PNG

    I look forward to a more complex support model. So far this is good stuff.

  2. Thanks zugok thanked for this post
    Likes zugok liked this post
  3. #22
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    2,936
    Post Thanks / Like
    Why a marvin hehe You could have used any other to test?

  4. #23
    3D Printer God(dess)
    Join Date
    Nov 2016
    Posts
    1,058
    Post Thanks / Like
    I started an Aphrodite print but the Inf filament failed to stick to the LokBuild. So I went for Marvin just to make sure the glue worked.

  5. Likes bolsoncerrado liked this post
 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •