Thanks Thanks:  4
Likes Likes:  0
Dislikes Dislikes:  0
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11
    3D Printer Noob
    Join Date
    Dec 2017
    Post Thanks / Like
    Ok anyone!!!! After adjusting bed level and finding hot end lose tried printing( glass/hairspray)using cura 3.0 recommended settings 200/60.. first layer seemed to stick went to take a shower and found a bit of a mess ... it seems the hairspray dries and print releases.... also tried glue( changed tape on the bed in between) and that didnít stick at all..

  2. #12
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Post Thanks / Like
    Hairspray MUST be dry before you start printing....If it still releases you must change strength or brand of hairspray.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts