-
Bad Overhang Print
I'm facing bad overhang print with my Cube3.
I use PLA with mythandar simplify3d profile (Medium 0.2mm layer).
Is it caused by my printer hardware(although I didn't see any cooling fan problem) or slicer profile?
Last edited by pangoentji; 12-06-2017 at 03:46 PM.
-
Administrator
A pic or two would certainly help...
-

Originally Posted by
bolsoncerrado
A pic or two would certainly help...

-
Administrator
If you printed that one wihtout supports, you can call this great overhangs! hehe
-
agreed. wish some of my prints would have those overhangs, usually ends up a birds nest!
-

Originally Posted by
ztoddman1
agreed. wish some of my prints would have those overhangs, usually ends up a birds nest!

Originally Posted by
bolsoncerrado
If you printed that one wihtout supports, you can call this great overhangs! hehe
How about this 3dbenchy?
-
Looks like it may be too hot for the filament you are using.
-

Originally Posted by
MegaloDon
Looks like it may be too hot for the filament you are using.
Will temperature adjustment on simplify3d works? Or Cube3 just use temp setting based on chip?
I put 190C on simplify3d setting.
-
It uses the settings from the .cube3 file.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
-

Originally Posted by
MegaloDon
It uses the settings from the .cube3 file.
Great! I will try 185 and see what happens