-
What would be causing this (key kaps)
Here is a link to what I printed https://www.thingiverse.com/make:424325
Seems as if its not printing layer?
This is what its supposed to look like (ignore the top part of the card holder. they modified it ) https://www.thingiverse.com/thing:2127340
This did it also on https://www.thingiverse.com/make:422965
Using cube print software. max settings
Calibrated bed before each print
-
Try not using the "solid" setting.
-

Originally Posted by
shawnhenson
It's caused by Cube Print software. This happens on a lot of prints that have a small area. The only time it doesn't happen is if you design it to an exact size that corresponds to the layer thickness.
You could try another slicer. >>> http://www.print3dforum.com/showthre...rs-with-cube-3
It will solve this problem.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes