Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2
  1. #1
    3D Printer Noob
    Join Date
    Nov 2017
    Post Thanks / Like

    Favorite Filaments?

    Hello All!

    I was wondering what all filaments people here like to use with the Cube 3? There is a post here in the forum but it seems derelict? I just recently bought some PLA filament from AMOLEN off of Amazon and it was junk! Brittle prints, bad stringing and it got too thick to fit through the drive gears. I couldn't even force it through. I just returned it this morning and ordered some PLA from MatterHackers to give that a shot. What do you all think?

  2. #2
    Super Moderator
    Join Date
    Nov 2016
    Post Thanks / Like

    It's not that it is derelict, it is more the case that people don't seem to think much of the filaments they buy so they also have no inclination to post those results. Or they already have a favorite and is either included, or they have a favorite and do not wish to share.
    Maybe the post should be stickied.
    Last edited by TommyDee; 01-24-2018 at 01:27 AM.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts