Robo 3d R1+ switching from Simplyfy 3D to Cura for a particular project.

[mercymar]

Hello everybody, I am having a lot of trouble trying to use Cura from which I have a very detailed profile for a project I am trying to print. I am unable to find the right settings withing it to print with my Robo 3d R1 plus. So far, just printing air. After I switch to S3D, the printer works fine. But the detailed profile from Cura, it is impossible to make it work within S3D as it has many variables set, that S3D lacks.

I will appreciate if I can get help or advise on how to make Cura work with my Robo 3D.
Thank you.

[migelraton]

Hello everybody, I am having a lot of trouble trying to use Cura from which I have a very detailed profile for a project I am trying to print. I am unable to find the right settings withing it to print with my Robo 3d R1 plus. So far, just printing air. After I switch to S3D, the printer works fine. But the detailed profile from Cura, it is impossible to make it work within S3D as it has many variables set, that S3D lacks.

I will appreciate if I can get help or advise on how to make Cura work with my Robo 3D.
Thank you.

I know this is an old post but did you ever get an answer? Just switched to Ultimaker
cura 4.5 and having the same issue.