It would be great to have a thread that focuses on the setup and usage of Cura 3.x.x versions targeting a Cube Pro (because that is what I have) at least.
I am trying to piece together all the random bits and pieces of information in other threads to get this to work if it is even possible. I am fed up with the crappy output from the CubePro slicer and it's lack of options to improve the results.
So, fill in the information below.....
Last edited by boilerbots; 04-15-2018 at 06:27 PM.
Progress already in trouble. The cubepro decoders can't decode the latest output files from the desktop software and when I encode the output from cura, the 2.02 firmware on my printer says that it is not valid. Hmmm.....
- - - - - - - - - -
Finally I am getting my printer to recognize the Cura ouput, the beginning lines with the '^' need to end with a <Ctrl-M> character or my printer says there is a problem.
- - - - - - - - - -
I guess I won't be contributing to this thread any more. I replaced the controller with a Smoothie board. Open hardware and open firmware. I can use any slicer I want and after only a few test prints am seeing pretty good results.