Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 5 of 5

Thread: CRS10 bed level

  1. #1
    3D Printer Noob
    Join Date
    May 2018
    Posts
    3
    Post Thanks / Like

    Angry CRS10 bed level

    I cant adjust bed level. The bed is all the way down and the extruder still sits on top of the glass. The z axis switch is all the way up. Is there a certain height the gantry has to be off the frame?
    This was supposed to be easy to do!

  2. #2
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    3,081
    Post Thanks / Like
    Not sure if I follow you.... Extruder needs to sit on top of the glass. Can you picture the problem?

  3. #3
    3D Printer Noob
    Join Date
    May 2018
    Posts
    3
    Post Thanks / Like
    I cant get the paper under the extruder as it still sits on top of the glass. The bed is all the way down. There is no space between the extruder and the bed.

  4. #4
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    3,081
    Post Thanks / Like
    Usually the problem people faces is the very oppostie! Is everything looking ok? The backslash, the Z endstop, everything OK no breakages, bents, no nothing?

    Did you get lengthy bed screws or are they short? Are they full of washers? Try removing them if any?

  5. #5
    3D Printer Noob
    Join Date
    May 2018
    Posts
    3
    Post Thanks / Like
    [QUOTE][Did you get lengthy bed screws or are they short? Are they full of washers? Try removing them if any?/QUOTE]
    Wouldnt know if they were short or long as Ive never had a 3d printer before. There are no washers. I fixed that problem but my z axis is still not moving.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •