Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 5 of 5

Thread: T14-t24

  1. #1
    Regular 3D Printer
    Join Date
    Apr 2018
    Posts
    34
    Post Thanks / Like

    T14-t24

    Hello,

    I am always starting to get a T14 error. It always happens after about 10 minutes into the print. I dont know what to do...

    Also, I noticed that the print will be heating, and get to the very end, and never start, unless I hold down the middle top fan and stop it from spinning. I think something might be wrong with my printer... =/

    Would anyone have any suggstions?

  2. #2
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    3,037
    Post Thanks / Like
    Replace the power source?

  3. #3
    3D Printer God(dess)
    Join Date
    Nov 2016
    Posts
    1,413
    Post Thanks / Like
    ...and when that isn't the problem, make sure the nozzle is fully seated in the heater block.
    If that push nut is too far down the barrel, it may not be making full contact with the heater block.

    Another tip has been to make sure the environment is at least 70*F that you are printing in.

    The other time this happens is when you have a chip in the opposite side and no nozzle present.

  4. #4
    Regular 3D Printer
    Join Date
    Apr 2018
    Posts
    34
    Post Thanks / Like
    I ordered a new power supply, however I am using mythandar's temp mod to print with PETG, and it works like a charm at 238* C

    - - - - - - - - - -

    i ORDERED THE NEW POWER SUPPLY.. NO LUCK.. IT KEEPS DOIGN IT!! =/

  5. #5
    3D Printer God(dess)
    Join Date
    Nov 2016
    Posts
    1,413
    Post Thanks / Like
    Check that your nozzle is fully seated in the heater.
    This is managed by the push nut on the stainless tube.

    I originally got this error from running in a cold room.
    That printer is back at 3DS however.

    But there are suggestions out there that insulating something inside the heater assembly does help.

    http://www.print3dforum.com/showthre...ll=1#post40769

    Since your solution is the same, I suspect this is your solution as well.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •