Print ABS Filament

[scottyblue77]

Little bit improvement, printing without skirt, with 2mm support and slower 55 and slice setting wanted diameter out of nozzle to 0,28 instead of 0,25 before.

Who know other setting to get oberlap of lines ?

ImageUploadedByTapatalk1427208899.338243.jpgImageUploadedByTapatalk1427208915.502952.jpg

[BobenhamHotspur]

You may have the extruder set too high as Holgamods over on Facebook has checked his hot end temp with a laser device and it reads ~22 deg higher than the software reports from the sensor. I also print my ABS @215-220 and get good results which kind of collaborate his findings, so it may be worth trying a lower temp.